discharge flow meaning in Chinese
出流
Examples
- On the basis of the previous studies , a systematical study on the test and analysis of the atomization model is made herein based on both the prototype test and model test for jiangya dam , and then the data processing system for the atomized water particle size is developed as well ; which is a new trial carried out for the model law for the intensity of rainfall from atomization of flood - discharging flow
摘要在以往的研究成果基础上，结合江垭大坝原、模型测试成果，对雾化模型的测试分析技术进行了系统研究，开发了雾化粒度数据处理系统，对泄洪雾化雨强的模型律进行了新的探索。 - The result show that the position of free surface is higher because of frusta of brake , especial obvious in the head of frusta of brake ; flux coefficient and pressure on dam are quite influenced by type of frusta and 3 a type frusta of brake relative to 2 type frusta of brake has bigger flux coefficient and smaller pressure on dam ; obvious influence of ability of discharge flow for different ratio of thickness of frusta and breadth of brake and pressure on dam reduces with increasing ration of thickness of frusta and breadth of brake , while bigger flux coefficient is obtained when tlb = 0 . 2
结果表明，闸墩河海大学博士论文的存在抬高了水面线的位置，其中在闸墩头部尤其明显;墩型对流量系数和坝面压力影响较大， 3a型闸墩相对于2型闸墩具有更大的流量系数和更小的坝面压力:不同的墩厚闸宽比t / b对泄流能力也将产生显著的影响，随着墩厚闸宽比的增加，坝面压力降低，而当t / b二0 . 2时溢流坝具有更大的流量系数。 - Then pid flow rate control algorithm is introduced . all experiments made in this chapter are about measuring the valve parameters according to spool positions , single actuator flow rate control by the calculated flow rate feedback control method , free flow rate dividing control under the sufficient pump discharge flow rate situation , proportion flow rate dividing and flow rate dividing based on meter - in flow rate feedback control method under insufficient pump discharge flow rate situation . the results of all experiments proved that the method presented in this thesis is an effective way to overcome the unreasonable flow rate dividing when simultaneously operating multi - actuators with different inertia loads
第四章介绍了多执行器复合控制实验系统和实验方法；介绍了实验采用的流量控制的pid算法；并测定了执行器控制阀和阀芯位移相关的系数；做了单个执行器计算流量反馈流量控制、流量足够情况下多执行器流量任意分配、流量不足情况下多执行器按比例调节流量分配和多执行器进油侧流量反馈分流控制实验；通过实验说明了论文提出的分流控制方法能实现大小惯性负载复合操作时的合理分流。 - Chapter 3 gives an introduction to the flow rate dividing principle based on meter - in flow rate feedback control of multi - actuators control system . special analysis about simultaneously operating multi - actuators with different inertia loads is made . finally the results of simulation proved that the new method is an effective way to improve the flow - used ratio when the pump discharge flow rate is insufficient
第三章介绍了基于执行器进油侧流量反馈的分流控制的原理，并针对大小惯性执行器同时起动时采用该分流控制方法进行了具体分析；最后通过仿真说明该分流控制方法能在大小惯性执行器同时起动并在泵输出流量不足的情况下有效提高泵输出流量的利用率，并能实现优先级和分流比混合控制。